Infrared Board Cable - HP ENVY x360 15 Maintenance And Service Manual

Infrared board cable

Table 5-8 Infrared board cable spare part information
Description
Infrared board cable
Before removing the infrared board cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
6. Remove the fan (see
7. Remove the heat sink (see
Remove the infrared board cable:
1. Release the zero insertion force (ZIF) connector (1) to which the infrared board cable is connected, and then
disconnect the infrared board cable from the system board.
2. Release the ZIF connector (2) to which the infrared board cable is connected, and then disconnect
the infrared board cable from the infrared board.
3. Remove the infrared board cable (3).
Reverse this procedure to install the infrared board cable.
Bottom cover on page
Fan on page 34).
Heat sink on page 35).
25).
Front speakers on page
Component replacement procedures
Spare part number
L93189-001
27).
37