HP ENVY x360 13 Maintenance And Service Manual page 42

1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Disconnect the battery cable from the system board (see
Remove the WLAN module:
1. Remove the shield (1) that secures the WLAN antenna cables to the WLAN module.
2. Disconnect the WLAN antenna cables (2) from the WLAN module terminals.
NOTE:
WLAN antenna cable connects to the WLAN module #2/Aux terminal.
3. Remove the Phillips M2.0×3.0 screw (3) that secures the WLAN module to the system board. (The WLAN
module tilts up.)
4. Remove the WLAN module (4) by pulling the module away from the slot at an angle.
NOTE:
36 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Bottom cover on page
The #1/Main WLAN antenna cable connects to the WLAN module #1/Main terminal. The #2/Aux
WLAN modules are notched to prevent incorrect installation.
(Preparation for disassembly on page
33).
Battery on page
33).
34).
ENWW