Touchpad - HP ENVY x360 13 Maintenance And Service Manual

Remove the touchpad cable:
1. Detach the touchpad cable (1) from the top cover. (The touchpad cable is attached to the top cover with
double-sided adhesive.)
2. Release the ZIF connector (2) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the system board.
3. Release the ZIF connector (3) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the touchpad.
4. Remove the touchpad cable (4).
Reverse this procedure to install the touchpad cable.

Touchpad

To remove the touchpad, use this procedure and illustration.
Table 5-8 Touchpad description and part number
Description
Touchpad
NOTE: The touchpad spare part kit does not include the touchpad bracket or touchpad cable. The touchpad bracket is not available as a
spare part. The touchpad cable is available in the Cable Kit, spare part number L94509-001.
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery (see
52 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Bottom cover on page 33).
Battery on page 34).
Spare part number
M15279-001
33).
ENWW