Toyota Land Cruiser Station Wagon Owner's Manual page 687

686
7-3. Do-it-yourself maintenance
 Front fog lights (if equipped)
 Cornering lights (if equipped)
 Side turn signal lights
 Tail lights
 Stop lights
 Rear turn signal lights (LED type)
(if equipped)
 Rear fog lights (if equipped)
 Back-up lights
 High mounted stoplight
 License plate lights
 Outer foot lights (if equipped)
 Running board lights (if
equipped)
LED lights
The lights other than the rear turn signal
lights (bulb type) (if equipped) each con-
sist of a number of LEDs. If any of the
LEDs burn out, take your vehicle to your
Toyota dealer to have the light replaced.
Condensation build-up on the
inside of the lens
Temporary condensation build-up on
the inside of the light lens does not indi-
cate a malfunction. Contact your Toyota
dealer for more information in the follow-
ing situations:
Large drops of water have built up on
the inside of the lens.
Water has built up inside the light.
When replacing light bulbs
P.684
Replacing light bulb
Rear turn signal lights (bulb
type) (if equipped)
1
Open the back door and remove
the cover.
1
Remove the 3 claws of the
cover using a flathead screw-
driver as shown in the illustra-
tion.
To prevent damage to the unit, cover
the tip of the flathead screwdriver with a
rag.
When removing the cover, use a screw-
driver of an appropriate size.
2
Remove the 3 claws by pulling
the cover backward.
2
Remove the securing screws
and remove the light unit.
Remove the light unit by pulling it
directly backward from the rear of the