Table of Contents
Advertisement
3
Firmly depress the brake pedal
and check that
played on the multi-information
display.
4
Press the engine switch shortly
and firmly.
Vehicles with fingerprint authentica-
tion system: Use the customization
function to turn the fingerprint
authentication system off. The
engine can be started even in this
state, as long as you are holding
the electronic key. (P.776)
In the event that the engine still
cannot be started, contact your
Toyota dealer.
Stopping the engine
Shift the shift lever to P, set the parking
brake and press the engine switch as
you normally do when stopping the
engine.
Replacing the key battery
As the above procedure is a temporary
measure, it is recommended that the
electronic key battery be replaced
immediately when the battery is
depleted. (P.679)
Alarm (if equipped)
Using the mechanical key to lock the
doors will not set the alarm system.
If a door is unlocked using the mechani-
cal key when the alarm system is set,
the alarm may be triggered. (P.111)
Changing engine switch modes
Release the brake pedal and press the
3
engine switch in step
The engine does not start and modes
will be changed each time the switch is
pressed. (P.259)
8-2. Steps to take in an emergency
If the vehicle battery is
discharged
is dis-
The following procedures may
be used to start the engine if
the vehicle's battery is dis-
charged.
You can also call your Toyota
dealer or a qualified repair
shop.
Restarting the engine
If you have a set of jumper (or
booster) cables and a second vehi-
cle with a battery, you can jump
start your vehicle by following the
steps below.
1
Confirm that the electronic key
is being carried.
When connecting the jumper (or
booster) cables, depending on the situ-
ation, the alarm may activate and the
doors locked. (P.112)
2
Open the hood (P.640) and
keep the engine compartment
cover opened or removing the
above.
cover (if equipped). (P.644)
729
8
Advertisement
Table of Contents
