Nakayama MB6000 Manual page 24

WARNING
1) Training
a) read the instructions carefully. Be familiar with the controls and the proper use of the
equipment;
b) never allow children or people unfamiliar with these instructions to use the machine. Local
regulations can restrict the age of the operator;
c) never work while people, especially children, or pets are nearby;
d) keep in mind that the operator or user is responsible or accidents or hazards occurring to other
people or their property.
2) Preparation
a) while working, always wear substantial footwear and long trousers. Do not operate the
equipment when barefoot or wearing open sandals;
b) thoroughly inspect the area where the equipment is to be used and remove all objects which can
be thrown up by the machine;
c) WARNING-Petrol is highly flammable:
-store fuel in containers specifically designed for this purpose;
-refuel outdoors only and do not smoke while refueling;
-add fuel before starting the engine. Never remove the cap of the fuel tank or add petrol while
the engine is running or when the engine is hot;
-if petrol is spilled, do not attempt to start the engine but move the machine away from the area
of spillage and avoid creating any source of ignition until petrol vapours have dissipated;
-replace all fuel tank and container caps securely;
d) replace faulty silencers;
e) before using, always visually inspect to see that the tools are not worn or damaged. Replace worn
or damaged elements and bolts in sets to preserve balance.
3) Operation
a) do not operate the engine in a confined space where dangerous carbon monoxide fumes can
collect;
b) work only in daylight or in good artificial light;
WARNING
c) always be sure of your footing on slopes;
d) walk, never run with the machine;
e) for wheeled rotary machines, work across the slopes, never up and down;
f) exercise extreme caution when changing direction on slopes;
g) do not work on excessively steep slopes;
h) use extreme caution when reversing or pulling the machine towards you;
i) do not change the engine governor settings or overspeed the engine;
j) start the engine carefully according to manufacturer instructions and with feet well away from
the tool(s);
k) do not put hands or feet near or under rotating parts;
l) never pick up or carry a machine while the engine is running;
m) stop the engine:
-whenever you leave the machine;
-before refuelling;
n) reduce the throttle setting during engine shut down and, if the engine is provided with a shut-off
valve,turn the fuel off at the conclusion of working;
4) Maintenance and storage
a) keep all nuts, bolts and screws tight to ensure the equipment is in safe working condition;
b) never store the equipment with petrol in the tank inside a building where fumes can rech an poer
flame or spark;
c) allow the engine to cool before storing in any enclosure;
d) to reduce the fire hazard,keep the engine,silencer,battery compartment and petrol storage area
free of vegetative material and excessive grease;
e) replace worn or damaged parts for safety;
f) if the fuel tank has to be drained,this shall be done outdoors.
24
.N
WWW
T
AKAYAMA
.
OOLS COM