Clutch Cable Adjustment; Throttle Cable Adjustment; Belt Tension Adjustment - Nakayama MB6000 Manual

·Tighten a new spark plug 1/2 turn with the wrench to compress the washer if you are reuse a plug,
it should only take 1/4-1/2 turn after the plug seats.
CAUTION:
The spark plug must be securely tightened. An improperly tightened plug can become very hot and
possibly damage the engine. Never use a spark plug with an improper heat range.

5.Clutch Cable Adjustment

Measure the free play at the lever tip.
Free play: 3-8mm (0.1-0.3 in)
If the free play is incorrect, loosen the lock nut and turn the adjusting bolt in or out as required.
(1) LOCK NUT
(2) ADJUSTING BOLT
After adjustment, tighten the lock nut securely. Then start the engine and check for proper clutch
lever operation.

6.Throttle Cable Adjustment

Measure the free play at the lever tip.
Free play: 5-10mm (0.2-0.4 in)
If the free play is incorrect, loosen the lock nut and turn the adjusting nut in or out as required.
(1) THROTTLE LEVER
(2) ADJUSTING NUT
(3) LOCK NUT

7. Belt Tension Adjustment

Adjust the clutch lever free play
The standard belt tension is 60-65mm (2.4-2.6 in) at the tension roller with the clutch engaged
(clutch lever is squeezed).
To adjust, loosen the four engine mounting bolts and the engine stay tightening bolt and move the
engine forward or reverse to get proper tension of the belt.
NOTE: After adjusting the tension, make sure that the outside face of the drive pulley is flush with
37
.N
WWW
T
AKAYAMA
.
OOLS COM