Transporting/Storage - Nakayama MB6000 Manual

the outside face of the driven pulley by using a straight gauge.
(1) ENGINE MOUNTING BOLTS
(2) ENGINE STAY TIGHTENING BOLE
Loosen the belt stopper attaching bolts.
Adjust the clearance between the belt stopper and the belt as illustrated with the clutch lever
squeezed.
(1) BELT STOPPERS
TRANSPORTING /STORAGE
WARNING When transporting the tiller, turn the fuel valve OFF and keep the tiller level to
prevent fuel spillage. Fuel vapor or spilled fuel may be ignited.
Before storing the unit for an extended period:
1. Be sure the storage area is free of excessive humidity and dust.
2. Drain the fuel.
WARNING Gasoline is highly flammable and explosive under certain conditions. Do not smoke
or allow flames or sparks in the area.
·With the fuel valve turned OFF, remove and empty the fuel strainer cup.
·Turn the fuel valve ON and drain the gasoline in the fuel tank into a suitable container.
·Replace the fuel strainer cup and tighten securely.
·Drain the carburetor by loosening the drain knob. Drain the gasoline into a suitable container.
(1)O-RING
(2)FUEL STRAINER CUP
(3)DRAIN KNOB
3. Pull the starter grip until resistance is felt. Continue pulling until the notch on the starter puller
aligns with the hole on the recoil starter.
At this point, the intake and exhaust valves are closed and this will help to protect the engine from
internal corrosion.
(1) Align the notch on the starter
pulley with the hole at the top
of recoil starter .
38
.N
WWW
T
AKAYAMA
.
OOLS COM