AT&T MERLIN II Manual page 8

This procedure erases all recorded announcements.
NOTE:
1 Enter authorized caller mode.
a Dial the MERLIN II Attendant extension number from a Touch-Tone phone, preferably a single-line
set.
Wait for an answer.
b
c followed by your authorized caller code and #.
Dial " immediately
If you are programming from a multiline Touch-Tone phone connected to the MERLIN II
NOTE:
system control unit, you must enter an additional pound (#) sign each time a pound (#)
sign appears in a programming command.
2 Dial *49.
This step erases all announcements. To exit without reallocating the time for each
NOTE:
announcement, skip to step 8.
3 Dial two digits representing the maximum length in seconds for the Day announcement.
4 Dial two digits representing the maximum length in seconds for the Night announcement.
5 Dial two digits representing the maximum length in seconds for the Transfer Fail announcement.
Dial two digits representing the maximum length in seconds for the Hold announcement.
6
7 Dial two digits representing the maximum length in seconds for the Connect announcement.
8 Dial #.
The two-beep confirmation tone sounds.
Continue programming.
9
o r
Exit authorized caller mode by dialing *#.
10 To disconnect, dial #.
2 MERLIN II Attendant Planning Form C
How to Program: