AT&T MERLIN II Manual page 7

MERLIN II Attendant Planning Form C
Each announcement has been assigned a default duration (in seconds) as foIlows:
The total duration for all announcements cannot exceed 64 seconds.
Use this form if you want to perform either of the following:
Change length of any announcement
the
Remove an announcement from use by changing its duration to zero
Caution: All previously recorded announcements are erased when you use the programming procedure on
the back of this form to reallocate (change) announcement durations. You must rerecord all
announcements after using this procedure.
REALLOCATING ANNOUNCEMENT TIME
Enter a new duration for your announcements in seconds. Then, record these changes in the table below
using the foIlowing instructions:
If your entry is less than 10, you must enter a leading zero. For example, five seconds is entered as 05.
T remove an announcement from use, change its time length to zero (00).
O
If you make any changes, make sure the total duration for all announcements
seconds.
Use the programming instructions at the back of this form to enter these changes.
Announcement Time Reallocation
Day
Night
Transfer Fail =14
Hold
Connect
Announcement
Day
Night
Transfer Fail
Hold
Connect
=
20
= 20
= 05
= 05
is not greater than 64
Duration
MERLIN II Attendant Planning Form C
1