AT&T MERLIN II Manual page 6

Remember to set the current date and time for the MERLIN II Attendant. Refer to the
NOTE:
programming information that came with the unit for further information. If you do not set the
MERLIN 11 Attendant clock, the unit remains in Day mode at all times.
1 .
Enter authorized caller mode.
a Dial the MERLIN 11 Attendant extension number from a Touch-Tone phone, preferably a single-line
set.
b for an answer.
Wait
c Dial * immediately followed by your authorized caller code and #.
The two-beep confirmation tone sounds.
If you are programming from a multiline Touch-Tone phone connected to the MERLIN 11
NOTE:
system control unit, you must enter an additional pound ( # )
sign appears in a programming command.
Dial *73 followed by a code for the day of the week.
(1) Sunday, (2) Monday, (3) Tuesday, (4) Wednesday, (5) Thursday (6) Friday (7) Saturday (8) Sunday
(9) Entire week -7 days.
Dial two digits for the opening hour (00 through 23) using 24-hour time (00 is midnight).
Dial two digits for the opening minute (00 through 59).
Dial two digits for the closing hour (00 through 23) using 24-hour time (00 is midnight).
Dial two digits for the closing minute (00 through 59).
The two-beep confirmation tone sounds.
If you hear the three-beep (error) tone, return to step 2.
NOTE:
Repeat steps 2 through 6 of this procedure for each additional day as needed.
Continue programming.
or
Exit authorized caller mode by dialing *#.
To disconnect, dial #.
2 Attendant Planning Form B
MERLIN II
How to Program:
each time a pound ( # )
sign