AT&T MERLIN II Manual page 14

To enter your supervised transfers only:
Enter authorized caller mode.
I
a Dial the MERLIN II Attendant extension number from a Touch-Tone phone, preferably a single-line
set.
b Wait for an answer.
c Dial * immediately followed by your authorized caller code and #.
If you are programming from a multiline Touch-Tone phone connected to the MERLIN 11
NOTE:
system control unit, you must enter an additional pound ( # ) sign each time a pound ( # )
sign appears in a programming command.
2 Dial *3 followed by the route number and the Day Primary Extension number.
3 Dial #.
4 Dial the Day Secondary Extension number
If you are not entering a secondary extension, skip to step 5.
NOTE:
5 Dial #.
6 Dial the Night Primary Extension number.
7 Dial #.
8 Dial the Night Secondary Extension number
If you are not entering a secondary extension, skip to step 9.
NOTE:
9 Dial #.
The two-beep confirmation tone sounds.
If you hear the three-beep (error) tone, return to step 2.
NOTE:
10 To enter additional supervised transfer routes, repeat steps 2 through 9.
11 Continue programming.
or
Exit authorized caller mode by dialing * #.
12 To disconnect, dial #.
2 MERLIN II Attendant Planning Form F
How to Program: