IEMCA VIP 80 Manual For Use And Maintenance page 89

n o . 2 9
29
: > 0
Phase
machining
Defines the positive or negative corrections of point F (max. bar
pusher feed point).
Application examples:
- it is required when ejecting with the bar pusher (point b, para-
meter 21);
- it is required when the lathe collet is replaced with one having
different dimensions.
When the operator corrects the F point, parameter 1 is modified
as shown in the picture; it is then necessary to check and, if re-
quired, correct the value of parameter 1 .
M a x . f e e d i n g
( mm )
27
INSTALLATION PROCEDURE
p o s i t i o n
F
IDM - 61.017 Ec.0
F
F
F
IDM - 61.018 Ec.0
2
302.061
m o d i f i c a t i o n
( i n c h e s )
No adjustment
With adjustment +
for ex. +10
With adjustment -
for ex. -10