IEMCA VIP 80 Manual For Use And Maintenance page 83

n o . 7
7
: >
Phase
machining
It defines the speed value in "FEEDING". Accepted values range from 0 to 500 mm/sec.
n o . 8
8
: >
Phase
machining
Acceleration related to parameter 7 . Accepted values range from 0 to 500 mm/sec
n o . 9
9
: >
Phase
machining
At the "FEEDING" signal from the lathe, the bar pusher keeps running for the
set time.
Example of application: It must be used when the mechanical opening
movement of the collet is slow (double-cone collet).
n o . 1 0
10
: >
Phase
machining
After the issue of the "COLLET CLOSED" signal by the lathe, the bar pusher
continues to push for the set time.
Example of application: it must be used when the mechanical closing
movement of the collet is slow (double-cone collet).
n o . 1 1
11
: >
Phase
bar change
Defines the length of the slow speed section before the entry into the
collet. This value is referred to point C (facing point).
Along this section the bar moves at the collect entry speed ( parameter 12 ).
O p e n c o l l e t
2 0 0 ( mm / s e c )
( 1 0 0 )
O p e n c o l l e t
5 0 0 ( mm / s e c * s e c )
( 2 8 0 )
O p e n c o l l e t
0 ( s e c )
C l o s e d c o l l e t
1 ( s e c )
C o l l e t e n t r y
2 0 0 ( mm )
INSTALLATION PROCEDURE
s p e e d
a c c e l e r a t i o n
t h r u s t
d e l a y
t h r u s t
s l o w i n g
IDM - 61.009 Ec.0
21
302.061
2
.
d e l a y
d o w n
( i n c h e s )
C
Parameter 11
2