IEMCA VIP 80 Manual For Use And Maintenance page 134

n o . 9 0
90
: > 0
0 - K37 enabled with guide channels closed in manual mode.
1 - Bar feeder in manual mode and lathe in automatic mode.
0
The bar feeder goes into "ALARM" when, in "MANUAL" cycle, movements are performed (e.g.:
"bar pusher lifting", "guide channel lifting"). The bar feeder exits from the "WORKING" phase, whi-
ch will need to be reset. "BAR FEEDER WAITING" will appear on the display.
1
If the bar feeder is in manual mode, at the feeding first signal it goes into "ALARM".
CAUTION: With the "MANUAL/AUTOMATIC" signal from lathe, if the bar feeder is in "MA-
NUAL" mode from lathe, this safety is off.
n o . 9 2
92
Subparameters
S p e e d
A c c e l e r a t i o n
It defines the speed and acceleration with which the carriage is pushed back when the bar pusher
is lifted or lowered.
Wr o n g b a r
B a r p u s h e r
72
SETUP INFORMATION
f e e d e r
p h a s e
b a c k w a r d
m o t i o n
- 3 0 ( mm / s e c )
3 0 0 ( mm / s e c * s e c )
3
302.061