IEMCA VIP 80 Manual For Use And Maintenance page 109

E r r o r : p r o t e c t e d
26
ERROR
The feed motor has stopped and is
not restarting.
E r r o r : s t a t i o n a r y
27
i m p u l s e s
ERROR
During the facing stroke, the bar has
met an obstacle before reaching the
section defined by parameter 11 .
C
parameter 11
facing flag
IDM - 61.021 Ec.0
INSTALLATION PROCEDURE
m o t o r
CAUSE
There is a problem with the drive of
the motor.
The motor is shorted
The temperature of the drive heat
sink has reached the maximum per-
missible value
p o s i t i o n
CAUSE
There is an obstacle in the spindle
Encoder fault.
Card fault.
47
d r i v e
SOLUTION
Check the drive: The green LED of
the control panel must be lighted.
Check the shorted motor.
Let the drive cool and wait about 15
minutes before powering on again.
Check if the problem occurs again.
b e f o r e
SOLUTION
Check that there are no impedi-
ments, or diameter differences such
as to prevent the movement of the
bar .
Check the number of revolutions of
the spindle.
Check that the encoder is driven
correctly in the rotation.
Check on the display the position of
the bar pusher carriage, and verify
that the position change indicated
corresponds to the actual movement.
Contact IEMCA technical assi-
stance.
2
302.061