IEMCA VIP 80 Manual For Use And Maintenance page 77

❑ Entering or modifying the operator parameter value
Ex:
n o . 1
– – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – –
I n s ) P r e s s
Ex:
n o . 1
– – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – –
I n s ) P r e s s
type the value to
assign. Ex:
it appears:
n o . 1
– – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – –
I n s ) P r e s s
❑ Subparameters
press many times:
press many times:
The required parameter should be displayed
B a r e n d a d j u s t m e n t
1 1 5 ( mm )
E N T E R ) t o
select the parameter value by recalling the selecting cursor
press:
0
the parameter value blinks
B a r e n d a d j u s t m e n t
1 1 5 ( mm )
1 1 5
1
E N T E R ) t o
120
plus
the value in inches will be shown automatically, or, if the value is entered in
inches, it will be shown in millimetres (mm)
B a r e n d a d j u s t m e n t
1 2 0 ( mm )
E N T E R ) t o
Suspending the selection function
press:
the parameter value stops blinking. Besides, if the value has been modified but
the modification has not been saved, the valid value is the one preceding the
modification.
Some parameters have subparameters.
To access the subparameters, scroll down the parameter screen image
to return to the parameter screen image
INSTALLATION PROCEDURE
c o n f i r m
c o n f i r m
c o n f i r m
15
2
302.061
) M o v e
←→
) M o v e
←→
) M o v e
←→