IEMCA VIP 80 Manual For Use And Maintenance page 108

E r r o r : t h r e a d
23
ERROR
The lathe failed to the thread on the
current piece.
E r r o r : m a n / a u t
24
ERROR
The lathe is not in AUTOMATIC
mode.
( E r r o r : . . . )
25
INSTALLATION PROCEDURE
s a f e t y
CAUSE
Threading device fault.
Threading device fault.
The bar did not move forward at the
last "COLLET OPENING".
f r o m
CAUSE
An interface signal from the lathe is
keeping the bar loader in MANUAL
MODE.
46
Check the correct operation of the
device on the lathe.
Check the correct operation of the
device (S99).
Check the correct opening of the
lathe collet and the push of the bar
loader ( parameter 34 ).
l a t h e
Check the "INTERFACE FROM
LATHE" signal.
2
302.061
SOLUTION
SOLUTION