Switch on the power to the air-conditioner at the isolation breaker.
Start the air-conditioner by using the remote control and pressing the "ON" button. Then select fan
function by pressing the "MODE" button.
Operate in low FAN,medium FAN and high FAN in turn to check normal operation.
Select COOL mode. Adjust the set point temperature to three degrees lower than the room temperature.
The unit will start to blow cold air shortly after the compressor starts.
Select HEAT mode. Adjust the set point temperature to three degrees higher than the room temperature.
The unit will start to blow hot air after the compressor starts and the inside coil reaches temperature.
After selecting the COOL or HEAT mode, the compressor may
delay starting for 3 minutes. This is a feature to protect the compressor.
Instructions for Use
Note
10