Install plenum mounting bracket
A. Assemble M8 bolts, washer and metal fixing plates in
order shown.
B.
Make sure the four fixing plates are 10mm/
distance from the plenum mounting bracket in order to
adjust angle during installation.
C.
Push the plenum mounting bracket upward into the
square installation hole.
.
D. Tighten the M8 bolts to make sure the plenum mounting
bracket is connected with outdoor unit tightly.
E.
It's suggested that when screwing the bolt, torque
should be 7N.m/ 5ft-lbs which could make the
connection between outdoor unit and outlet gasket
perfect. Important – Do not exceed 7 N.m/5 ft-lbs!
Damage caused by over tightening these bolts will not
be covered by warranty.
3
/
"
8
F.
Check if the plenum mounting bracket is completely
embedded into the square hole.
14
Bolt
Air flow separation baffle
8
3
/
"
16
9
1
/
"
4
Ducted air system