Houghton BELAIRE Owner's Manual page 22

LIGHT
This function only applies to air conditioners with LED lights.

Control of the LED lights is independent of the ON/OFF"

lights ON/OFF. When the LED light is ON long press the"LIGHT" key for 3 seconds to set the LED lights brightness and
can be adjusted by up"▲" and down"▼"key.
The remote controller should be operated by directing it toward the wall pad controller, which

will beep once when a signal is received.
The air-conditioner features power cut memory and automatic start up after power is restored.

During operation in heating mode with low ambient temperatures the unit may occasionally

enter an automatic defrost cycle to remove ice from the outside coil. Heating will temporarily
cease, and the wall pad controller will show "dF". Heating will resume as soon as the coil is
defrosted.
When the environmental temperature is lower than 0℃/ 32⁰ F, the heating effectiveness is

reduced.
If the device is left unused for long time, please remove the batteries from the remote

controller.
"key. Short press the "LIGHT" key to control the LED
Tips
19