Instructions For Use - Houghton H2000C Owner's Manual

 Switch on the power to the air-conditioner at the isolation breaker.
 Start the air-conditioner by switching to FAN mode to select the fan speed;
 Operate in low speed, medium speed and high speed in turn to check normal operation;
 To select the COOL mode, adjust the set point temperature to three degrees lower than the room
temperature, the unit will start to blow cold air after the compressor starts.
 To select the HEAT mode, adjust the setting temperature as three degrees higher than the room
temperature, the device will start to blow hot wind soon.
After selecting the COOL/HEAT mode, the compressor will have a
delay start for three minutes.

Instructions for Use

Notice
16