Houghton BELAIRE Owner's Manual page 17

Celsius and Fahrenheit degree change
In any mode，press the"℃/℉"key to select temperature unit of Celsius and Fahrenheit.

Turn off
Press the on/off "

Timing function
Set clock and timer.

A. Press the"SET TIME"key, the Hour digit will flash. Press "▲"or"▼"key to set hour. Press the "HOUR/MIN" key, the
Minute digit will flash. Press"▲"or"▼"key to set minute. Clock setup is done.
B. Press the"SET TIME"key, until "ON" shows on the upper right side of the clock and hour digit flashes. Then press the
"HOUR/MIN" key, and "▲"or"▼"key, to set the desired time to turn the unit on.
C. Press the"SET TIME"key, until "OFF" shows on the lower right side of the clock and hour digit flashes. Then press the
"HOUR/MIN" key, and "▲"or"▼"key, to set the desired time to turn the unit off.
D. Clock and timer is now set. Keep on pressing the"SET TIME"key to check again clock and programmed time to turn unit
on and off. When all setup is done, after 10 flashes, it will return to clock display.
Timing to turn on: Press the "TIMER" key until "ON" flashes and shows the time to turn on. When "ON" is displayed

after its 10 flashes, and the current clock is displayed, then the setup of timing to turn the unit on is done.
Timing to turn off: Press the "TIMER" key until "OFF" flashes and shows the time to turn off. When "OFF" is displayed

after its 10 flashes, and the current clock is displayed, then the setup of timing to turn the unit off is done.
Timing to turn on and off: Press the "TIMER" key until "ON" and "OFF" flashes simultaneously and shows the time to

turn off. When "On" and "OFF" are displayed after their simultaneous 10 flashes, and the current clock is displayed, then
the setup of timing to turn the unit on and off is done.
Turn off timing function: Press the "TIMER" key.When it only shows the clock, the timer function is turned off.

Note: If the timer function is activated and the unit is not powered off, then the air conditioner will be turned on and off

according to the set time every day. Simple method to shut down the timer function: remove battery from the remote
control and then replace.The remote control will be restored to the factory settings, and the timer function is turned off.
"key again，the unit turns off and the panel will be blank.
14