Instructions For Use - Houghton BELAIRE H2400D Owner's Manual

1.Turn the power on at the circuit breaker.
2.Press the ON/OFF "
press the MODE button "
3.Cycle through the LOW, MED and HIGH fan speeds checking that all speeds run.
4.Set mode to COOL, adjust temperature via up/down buttons to 4˚C below the display temp (i.e.
room temp).
Note: There may be a delay of up to 3 minutes before the compressor starts.
5.Set mode to HEAT, similarly set temperature to 4˚C above the display temperature. Compressor
will start within three minutes. After a few minutes the fan will start and warm air will be
apparent.
Note: The fan will not begin blowing air until the inside coil has reached a temperature of at least
30 ⁰ C. This is to ensure that no cold draughts are produced when the unit is first heating up
.

Instructions for Use

" button and set the time and day (see operating instructions). Then
" to select FAN "
10
".
.