Houghton BELAIRE Owner's Manual page 9

Install outlet gasket
 Mare sure the roof is clean, dry and free from oil or grease.
 Take off the paper from the back of the outlet gasket and stick the outlet gasket onto the roof over the square hole.
 Press the outlet gasket to make sure the outlet gasket is closely adhered to the roof.
 Apply a bead of suitable sealant around the entire perimeter where the gasket meets the roof.
Install outdoor unit
 Place the outdoor unit over the outlet gasket and adjust position to make sure the 4 bolts under the outdoor unit are
aligned with the 4 corners of the square hole (360x360mm/14
adjusted a person needs to go to the inside of caravan to ensure the alignment.
 Do not push or pull the outdoor unit while it is resting on the gasket. Lift and align the unit before resting it back on the
gasket. Sliding the unit across the gasket may cause damage to the outlet gasket and lead to leakage of air and water.
 The 4 holes which receive M8 bolts on the base of the outdoor unit should align with the 4 corners of the square hole
(360x360mm/14 "x 14
3 /
16
") on the roof.
3 /
16
"x 14 ").When the position of outdoor unit is being
/ /
3 3
16 16
6