Confirm Installation Of Tcp/Ip On The Pc; Install Dial-Up Networking On The Pc - IBM E Server i Series Manual

Install PC modem for Windows XP
If you are installing a PC modem that requires specific drivers, use the instructions
that the modem manufacturer provides. Otherwise, follow these steps to install the
PC modem:
1. Click Start —> Settings —> Control Panel —> Phone and Modem Options.
2. If you are currently in the Modems tab of the Phone and Modem Options
folder, click Add and then click Next. Otherwise, if you are at the Install New
Modem window, click Next. The PC should find the new modem and report its
location.
3. When the window shows the modem it found, click Next to accept it. The PC
will now load the driver code to support it.
4. Click Finish to return you to the Phone and Modem Options folder.
5. Close the Phone and Modem Options folder.
6. Restart your PC before using the modem.
Note: If you were not prompted to restart the PC, restart the PC to force a
rewrite of changed data.

Confirm installation of TCP/IP on the PC

Use this section to satisfy the network requirements for Windows 98, Windows Me,
or Windows NT. Be sure you fully install and configure any network adapter cards
(such as LAN or Ethernet adapters) before starting the Operations Console
installation.
Confirm the existence of TCP/IP as follows:
1. Click Start and select Settings.
2. Click Control Panel.
3. Double-click Network. If you get a message indicating that Networking is not
installed, click Yes to install it.
4. If you are using Windows NT, click the Protocols tab. If you are using
Windows 98/Me, check for TCP/IP on the Configuration tab.
If TCP/IP is not installed on your PC, access your Windows Help by clicking Start
—> Help for instructions on installing TCP/IP.
Note: Windows 2000 Professional and Windows XP Professional automatically
installs with TCP/IP.

Install Dial-up Networking on the PC

You need to install Dial-Up Networking (DUN) if you are using Windows 98 or
Windows Me.
To install DUN on your system, perform these steps:
1. Click Start and select Settings.
2. Click Control Panel.
3. Click Add/Remove Programs.
4. On the Windows Setup tab, select Communications.
5. Click Details.
6. Make sure that the Dial-Up Networking box is checked on the
Communications dialog.
7. Click OK
Chapter 4. Set up Operations Console
53