IBM E Server i Series Manual page 72

10. Make sure that the Allow callers to access my local area network check box
11. If your network uses Dynamic Host Configuration Protocol (DHCP), click
12. Select the Allow calling computer to specify its own IP address check box.
13. Click Next.
14. Click Finish to save Incoming Connections.
Create and configure incoming connections for Windows XP
Complete the following steps to create and configure incoming connections for
Windows 2000.
10. Make sure that the Allow callers to access my local area network check box
11. If your network uses Dynamic Host Configuration Protocol (DHCP), click
66
iSeries: iSeries Access for Windows Operations Console
Note: If you have a virtual private network (VPN), leave this check box
unchecked.
Then, click Next.
8. Select or add any users to dial into the local console. Then, click Next.
9. Select the Internet Protocol (TCP/IP) check box (if needed). Then, click
Properties.
is selected.
Specify TCP/IP addresses automatically using DHCP. Then, go to the next
step. If your network does not use DHCP, click Specify TCP/IP addresses.
Then, do the following to specify the addresses:
a. In the From field, type the address 192.168.0.5
b. In the To field, type the address 192.168.0.24
c. The Total field shows 20
Then, click OK.
1. Click Start —>Settings —> Network Connections.
2. Click New Connection Wizard. The Welcome to the Network Connection
Wizard window appears.
3. Click Next.
4. Click Set up an advanced connection. Then, click Next.
5. Click Accept incoming connections. Then, click Next.
6. Select the check box for the PC modem that is going to receive the calls from
the remote console.
Make sure that the AS400 Operations Console Connection check box is not
selected. If other check boxes are selected, do not change them.
Then, click Next.
7. Click Do not allow virtual private connections.
Note: If you have a virtual private network (VPN), leave this check box
unchecked.
Then, click Next.
8. Select or add any users who are going to dial into the local console. Then,
click Next.
9. Select the Internet Protocol (TCP/IP) check box (if needed). Then, click
Properties.
is selected.
Assign TCP/IP addresses automatically using DHCP. Then, go to the next