Change Keyboard Definitions; Start The System Using A Manual Ipl - IBM E Server i Series Manual

These interactions show the expected behavior from the local console and remote
console users:
v No user has control of a server. Therefore, SERVER appears in the Current User
field and incoming control requests will be automatically granted.
v When a remote console requests control, control will be granted to the remote
console.

Change keyboard definitions

You can change your keyboard definition:
1. In the emulator window, using the drop-down menu, do the following:
a. Click Edit.
b. Click preferences.
c. Click keyboard.
2. Click User-Defined.
3. Click Browse, and then navigate to where iSeries Access for Windows was
installed. Then, under the Client Access folder, navigate to the Emulator folder,
followed by the Private folder.
4. Select your choice.
5. Click OK.
6. Click OK again.

Start the system using a manual IPL

Use this section to start your iSeries server by performing a manual initial program
load (IPL).
To perform a manual IPL, follow these steps:
1. Look at the Function/Data display on the iSeries control panel.
Systems with a keystick should show the mode as Manual and 01 B in the
Function/Data display.
2. If the system is in Manual mode and will IPL on the B side, then go to step 8.
If the system is not in Manual mode or not set to IPL on the B side, then
continue with step 3.
3. If the Function/Data display lit, then, continue with step 4.
If the Function/Data display is not lit, do the following before calling your
hardware service representative:
v Confirm that the electrical outlet is functioning by plugging in a suitable
device for the voltage.
v Ensure that the power cord is securely plugged into the system unit and
electrical outlet.
4. Press the Up or Down button until 02 appears in the Function/Data display.
Note: If your system uses a keystick, insert it now and select Manual by
using the Mode button.
5. Press the Enter button on the iSeries control panel.
6. Press the Up or Down button until B M appears in the Function/Data display.
If your system uses a keystick, select B. The Function/Data display should
show 02 B.
7. Press the Enter button on the iSeries control panel.
8. Press the Power button on the iSeries control panel.
Chapter 5. Manage Operations Console
83