IBM E Server i Series Manual page 62

11. To complete the setup:
12. Continue with Install Microsoft service pack.
56
iSeries: iSeries Access for Windows Operations Console
c. Go to step 13.
v To configure a local console to receive calls from a remote console, select the
following values:
a. For Allow remote clients running, select the TCP/IP check box and
clear any others (unless your own operation requires them).
b. For Encryption settings, click Allow any authentication including clear
text.
c. Click Configure (located to the right of TCP/IP).
d. For Allow remote TCP/IP clients to access, click This computer only.
e. Click Use Static address pool.
f. In the Begin field, type the address 192.168.000.005
g. In the End field, type the address 192.168.000.024
h. Select the Allow remote clients to request a predetermined IP address
check box.
i. Click OK.
j. Click OK again. Go to step 11.
v To configure as both a local console that receives calls and a remote console,
select the following values:
__ a. For Dial out Protocols, select the TCP/IP check box and clear any
others (unless your own operation requires them).
__ b. For Allow remote clients running, select the TCP/IP check box and
clear any others (unless your own operation requires them).
__ c. For Encryption settings, click Allow any authentication including
clear text.
__ d. Click Configure (located to the right of TCP/IP).
__ e. For Allow Remote TCP/IP client to access, click This computer
only.
__ f. Click Use Static address pool.
__ g. In the Begin field, type the address 192.168.000.005
__ h. In the End field, type the address 192.168.000.024
__ i. Select the Allow remote clients to request a predetermined IP
address check box.
__ j. Click OK.
__ k. Click OK again.
a. Click Continue.
b. If you get a message that says that the PC does not have a network
adapter installed, click OK.
c. If you get a message that says that Remote Access Service has been
successfully installed, click OK.
This message does not appear for all installations.
d. Click Close.
e. Click Yes to restart.