76
en | Configuration examples
15
Configuration examples
This chapter contains examples on how to configure selected devices in Bosch Video
Management System.
The following examples are available:
–
–
–
15.1
Adding a Bosch ATM/POS bridge
This example describes how to set up a Bosch ATM/POS bridge.
Configuring the ATM/POS bridge
1.
2.
3.
4.
5.
6.
7.
8.
9.
Adding the ATM/POS bridge to Bosch Video Management System
1.
2.
3.
4.
5.
6.
7.
8.
Configuration Client | V3 | 2010.07
Section 15.1 Adding a Bosch ATM/POS bridge, page 76
Section 15.2 Adding a Bosch Allegiant input alarm, page 77
Section 15.3 Adding and configuring 2 Dinion IP cameras with VRM recording, page 77
Ensure that the device is powered.
To configure the IP address and subnet mask of the device connect it to a COM port of
your computer with a RS232 cable (use the specified Bosch cable for connection). See
the Installation Manual of the Bosch ATM/POS bridge for details.
On this computer, start a Hyper terminal session (usually: Start > Programs >
Accessories > Communications > Hyper Terminal).
Type a name for the session and click OK.
Select the COM port number and click OK.
Enter the following COM port settings:
–
9600 bits/s
–
8 data bits
–
no parity
–
1 stop bit
–
hardware flow control
Click OK.
Press F1 for displaying the system options menu of the device.
Enter 1 to set the IP address and the subnet mask as required.
Leave the default settings for the ports:
–
port1: 4201
–
port2: 4200
Connect the device to your Bosch Video Management System network.
Start Configuration Client.
Click
Devices, expand the Logical Tree, expand
Bosch ATM/POS-Bridge.
The Add Bosch ATM/POS-Bridge dialog box is displayed.
Type a name as desired and type the settings that you configured earlier.
Click the Inputs tab and select the required inputs.
Click
to save the settings.
Click
Events.
Expand
, expand POS Bridge Input, click Data Input.
Configuration Manual
Bosch Video Management System
, right-click
, click Add
Bosch Sicherheitssysteme GmbH