Configuring Multiple Encoders / Decoders - Bosch LTC-1311-20 Configuration Manual

Bosch Video Management System
3.
6.6

Configuring multiple encoders / decoders

Main window
You can modify the following properties of multiple encoders and decoders at once:
–
–
–
NOTICE!
Changing the IP address of an IP device can make it unreachable.
To configure multiple IP addresses:
1.
2.
3.
4.
5.
6.
7.
To configure multiple display names:
1.
2.
3.
4.
5.
6.
7.
To update firmware for multiple devices:
1.
Bosch Sicherheitssysteme GmbH
Ensure that the following settings are applied:
– Serial port function: Transparent
– Baud rate: 19200
– Stop bits: 1
– Parity check: None
– Interface mode: RS232
– Half-duplex mode: Off
Display names
IP addresses
Firmware versions
On the Hardware menu, click IP Device Configuration....
The IP Device Configuration dialog box is displayed.
Select the required devices.
You can select multiple devices by pressing the CTRL- or the SHIFT-key.
Right-click the selected devices and click Set IP Addresses....
The Set IP Addresses dialog box is displayed.
In the Start with: field, type the first IP address.
Click Calculate.
In the End with: field, the last IP address of the range for the selected devices is
displayed.
Click OK.
In the IP Device Configuration... dialog box, click Apply.
The new IP addresses are updated in the selected devices.
On the Hardware menu, click IP Device Configuration....
The IP Device Configuration dialog box is displayed.
Select the required devices.
Multiple selection is possible by pressing the SHIFT key.
Right-click the selected devices and click Set Display Names...
The Set Display Names dialog box is displayed.
In the Start with: field, type the first string.
Click Calculate.
In the End with: field, the last string of the range for the selected devices is displayed.
Click OK.
In the IP Device Configuration... dialog box, click Apply.
The calculated names are updated in the selected devices.
On the Hardware menu, click IP Device Configuration....
The IP Device Configuration dialog box is displayed.
Configuration Manual
Configuring devices | en
Configuration Client | V3 | 2010.07
27