Wire Breakage/ Loose Contact - Felix printers Pro Series Troubleshooting Manual

Felix Pro L/XL Troubleshooting guide
8
December 10, 2019,

4.8 Wire breakage/ loose contact

Check in indicated probe contact cables are properly seated in their sockets.
If cables are properly placed in their sockets, wiggle the cables to see if the message "z-sensor triggered" appears
or disappears.
Inspect the flat cables if there are no folds and if they are properly seated in their connectors.
Worst case (and not a very likely to happen) is that the cables are broken or mounted contacts are loose.
www.FELIXprinters.com
FELIX Pro series