Felix printers Pro Series Troubleshooting Manual page 18

Felix Pro L/XL Troubleshooting guide
17
December 10, 2019,
No filament coming out or just a little bit? Try forcing it through by hand and see if anything comes out of it, if that
doesn't help try this method anyhow if you still can't get some material through you might have to change the
nozzle.
Set the extruder temp to 90°C (194°F) and the fan to 100%, you can do this in the printer status menu.
After that navigate to the move menu and turn off the motors so you can freely move the head around and
to make sure the extruder isn't engaged anymore.
www.FELIXprinters.com
FELIX Pro series