Check If Hot-End Disc Is Properly Fastened; Make Sure The Hot-End Cabling Is Properly Guided - Felix printers Pro Series Troubleshooting Manual

Felix Pro L/XL
4. Place back the hot-ends and see if the z-sensor triggered message is gone.

4.5 Check if hot-end disc is properly fastened.

Make sure the disc is firmly fastened to the hot-end body. Use a torx screwdriver to properly fix it.
Note: Also the bearing on the bottom should be properly fastened. This does not prevent z-sensor triggered
message, but ensures proper operation of the printer.

4.6 Make sure the hot-end cabling is properly guided.

Bad cable guiding could cause the following.
Inaccurate leveling.
-
Early triggering of the probe
-
What could happen is that during a home-x action the hot-end cable can touch the side of the frame causing a
sideways movement of the hot-end. This causes slight inaccuracy during homing.
FELIX Pro series
Troubleshooting guide
December 10, 2019,
www.FELIXprinters.com
6