Felix printers Pro Series Troubleshooting Manual page 20

Felix Pro L/XL
Repeat this process until the filament comes out cleanly, after this the machine should be able to extrude
properly again, this method is also useful when switching materials.
If you are unable to continue or have any questions, you can check at the support section of our website or you can
contact us directly:
Website: www.felixprinters.com/support
Email: support@felixprinters.com
Telephone: +31 (0)30 30 31 387
Address: Zeemanlaan 15, 3401MV IJsselstein, The Netherlands
Kind regards,
FELIXprinters
FELIX Pro series
Troubleshooting guide
December 10, 2019,
www.FELIXprinters.com
19