The Height Difference Between The Two Hot-Ends. (Manual); Adjusting The X, Y Distance Between Two Hot-Ends. (Semi-Automatic) - Felix printers Tec 4 User Manual

Printer calibration
7.1.3

The height difference between the two hot-ends. (manual)

The extruders must operate at the same height. Due to production tolerances this has to be calibrated. Please consult
the quick start manual how to do this.
When should you calibrate?
After changing/servicing one of the two hot-ends or nozzles.
-
When you see the first purge lines are significantly different in thickness.
-
7.1.4

Adjusting the x, y distance between two hot-ends. (semi-automatic)

The distance between two extruders need to be calibrated properly in order for a dual head print to successfully
finish. If this is not done properly printed lines from both extruders might overlap too much and cause a printed
failure.
When to do this?
After exchanging/servicing a hot-end
-
When adjacent features printed with both extruders do no not properly aligning.
-
FELIX Tec 4
User Manual
18 December 2017
www.FELIXprinters.com
7