Table of Contents
Advertisement
1.1.2.
Installation, start up and control
The flowmeter is designed and built in accordance with the latest state in technology, tested adequately and
has been shipped from the factory in good order and condition.
As the user, you are responsible to comply with all applicable safety regulations amongst others:
•
Instruction for the installation
•
Local standards and codes
The manufacturer has taken all measures to assure safe operation. The user has to make sure that the
equipment is positioned and installed in such a way that safe operation is not impaired.
The equipment is tested in the factory and shipped in good order and condition.
This manual contains information and notes of caution, which have to be adhered to by the user to assure a
safe operation.
•
Mounting, electrical installation, putting into operation and maintenance should only be done by
qualified personnel. The plant operator should authorize qualified personnel to operate on the
installation.
•
It is necessary that this manual is read and understood by these professionals and that they follow
the instructions as detailed in this manual.
•
Check all connections of the entire installation thoroughly, before putting the system into operation.
•
Do not put a damaged product into operation and make sure that that does not happen inadvert-
ently.
•
A malfunction of the equipment should only be handled and fixed by authorized and qualified
personnel
•
If it is not possible to repair the malfunction, put the equipment out of operation and make sure that
it cannot be put back into operation again.
•
Repairs not described in this manual may only be carried out by the manufacturer or by the
respective service organization.
Disclaimer of Liability
The manufacturer or their delegated representative is only liable in case of intend or gross negligence. The
accountability is limited to the value of the order issued at the time to the manufacturer.
The manufacturer is not liable for damages, originated from disregarding the safety instructions or violating
the instructions of the manual or operating conditions.
Consequential damages are excluded from the any liability.
1.2.
Environmental aspects
The products from E+E Elektronik
protection of the environment. Therefore, disposal of the product also should not lead to pollution of the
environment.
The single-variety components must be separated before the transmitter is disposed of. The electronic
components must be collected and as electronic scrap properly be disposed of.
are developed and designed in due consideration to the importance of the
®
5
Advertisement
Table of Contents
