Table of Contents
Advertisement
1.2.3
Mounting, Start-up and Operation
The MOP301 moisture in oil probe has been produced under state of the art manufacturing conditions,
has been thoroughly tested and has left the factory fulfilling all safety criteria. The manufacturer has taken
all precautions to ensure safe operation of the device. The user must ensure that the device is set up
and installed in a manner that does not have a negative effect on its safe use. The user is responsible
for observing all applicable safety guidelines, local and international, with respect to safe installation and
operation on the device. This user manual contains information and warnings that must be observed by the
user in order to ensure safe operation.
■
Mounting, start-up, operation and maintenance of the device may be performed by qualified staff only.
Such staff must be authorized by the plant operator to carry out the mentioned activities.
The qualified staff must have read and understood this user manual and must follow the
■
instructions contained within.
All process and electrical connections shall be thoroughly checked by authorized staff before putting the
■
device into operation.
■
Do not install or start-up a device supposed to be faulty. Make sure that such devices are not
accidentally used by marking them clearly as faulty.
A faulty device may only be investigated and possibly repaired by qualified, trained and authorized staff.
■
If the fault cannot be fixed, the device shall be removed from the process.
Service operations other than described in this user manual may only be performed by the manufacturer.
■
1.3
Environmental Aspects
Products from E+E Elektronik® are developed and manufactured observing of all relevant requirements
with respect to environment protection. Please observe local regulations for the device disposal.
For disposal, the individual components of the device must be separated according to local recycling
regulations. The electronics shall be disposed of correctly as electronics waste.
2
Scope of Supply
MOP301 – Moisture in Oil Probe with Digital Interface according to ordering code
■
Inspection certificate according to DIN EN 10204-3.1
■
■
Quick guide
User Manual MOP301 Digital Moisture in Oil Immersion Probe
5
Advertisement
Table of Contents
