Kessel Pumpfix F Standard Instructions For Assembly, Operation And Maintenance page 23

Fig. 13 shows the Comfort variant
Locking lever
muff
Pump remo-
val lever
Fig. 14
Fig. 15
4. Service and maintenance
Pump remo-
val lever
Fig. 16
Probe test
4.4 Pump removal:
The pump can be removed individually.
To do this, turn both pump removal levers
through 180°. This makes them fold out-
wards to the side so that the pump can be
lifted out.
Lock both sides!
Locking lever
muff
4.5 Motor installation:
The levelled drive shaft of the motor must
be in a vertical position (state on deli-
very). Move the locking lever of the ope-
rating valve on the locking cover to the
"CLOSED" position, insert the drive
motor into the drive groove from above,
and screw in place using the four M5 x 12
screws (TX25) on the locking cover (Fig.
16).
4.6 Removing motor ground installation
In this case, the outlet cover must be dis-
mantled to remove the motor. To do this,
open the locking lever and take the out-
let muff out. Loosen levers ② and ③ and
remove the bypass muff, to do this tilt
pump connection muff ④ away or remo-
ve the pump if necessary. After removing
the two cover locking levers ⑤ the outlet
cover can be removed. Now the motor
can be screwed off.
Motor installation
23
❹
❷ ❸
❶
❺