GRAPHTEC CE5000 Series Service Manual page 95

(10) Press the ENTER key to scan the printed cross mark. The plotter then plots a new cross mark based on
the reading of the printed cross mark.
The following menu is displayed.
X=00.0 Y=00.0
(11) Measure the offset between the printed cross mark and plotted cross mark.
Cross mark
plotted by the
plotter
(12) Set the offset value. Press the UP ARROW key or DOWN ARROW key to change the number.
Press the LEFT ARROW key or RIGHT ARROW key to change the digits of a number.
Press the ORIGIN key to select the X or Y direction.
Press the COND. key to select the + or - direction.
(13) Press the ENTER key to store the setting.
(14) Verify that the plotted cross mark line is located at the center of the printed cross mark line. Move the
pen to the printed cross mark area. Press the ENTER key to repeat the scan as described in step (10).
MARK ADJ SCAN
(15) Repeat steps (9) to (14) if the location of the plotted cross mark is incorrectly positioned. If the location of
the plotted cross mark is in the correct position, press the NEXT key and then turn off the power.
CE5000-UM-251-9370
Y
X
Printed target mark
7 ELECTRICAL ADJUSTMENTS
+Y
Media feed
direction
7-13
+X
-Y
-X