Table of Contents
Advertisement
2.
3.
2.5.5
Connecting WLAN Antennas
Install a single WLAN antenna for Single-Input Single-Output (SISO) or dual antennas
for Multiple-Input Multiple-Output (MIMO).
To install a WLAN antenna, do the following:
1.
2.
RUGGEDCOM RX1400
Installation Manual, 01/2021, C79000-G8976-1103-17
If required, connect the optional lightning arrestor, line amplifier or bandpass
filter to the antenna.
1
2
RUGGEDCOM RX1400
1
Shielded Coaxial Cable
2
Lightning Protector, Line Amplifier or Bandpass Filter
3
GPS Antenna
4
Figure 2.8
Antenna and Lightning Protector Assembly (Optional)
Using shielded coaxial cables, connect the antenna assembly to the ANT2 port
on the device.
Select an appropriate antenna. For a list of available WLAN antennas, refer to
"Available Antennas (Page
Mount the antenna to a pole or wall in an area that provides good signal
coverage and is away from any signal noise emanating from other
communications equipment.
3
2
17)".
Installing the Device
2.5.5 Connecting WLAN Antennas
4
23
Advertisement
Table of Contents
Need help?
Do you have a question about the SIMATIC NET RUGGEDCOM RX1400 and is the answer not in the manual?