Maintenance Procedures; Procedure 1. Load Thermal Paper Into The Printer (Optional) - Verathon BladderScan i10 Operation & Maintenance Manual

MAINTENANCE PROCEDURES

PROCEDURE 1. LOAD THERMAL PAPER INTO THE PRINTER (OPTIONAL)
Read the
1. Slide the printer door upward to unlock it, and then rotate the door down to open. Placing your thumb
on the outside of the printer and squeezing can make it easier to open the door.
2. If this is the first time you are loading the printer, there may be a sheet of paper in the printer
mechanism. Remove the paper sheet.
3. Place a roll of thermal paper inside the door as shown so that the loose end of the paper exits over the
top of the roll.
4. Hold the paper end so that it protrudes from the top of the printer, and then close the printer door.
Make sure the door clicks into place.
5. Tear off any excess paper protruding from the printer. For best results, pull the paper diagonally, starting
the cut on one side of the paper and finishing on the other.
56
0900‑5005 REV‑00
"Warnings & Cautions" section before performing the following task.