Steps
1. Place the display assembly on a clean and flat surface.
2. Align and slide the palm-rest and keyboard assembly on the display assembly.
3. Using the alignment posts, close the left and the right display hinges.
4. Replace the four screws (M2.5x5) and the two screws (M2x4) that secure the left and the right display hinges to the palm-rest and
keyboard assembly.
5. Connect the display cable to the system board and adhere the tape that secures the display-cable connector.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
wireless
card.
5. Remove the
solid-state drive/Intel Optane
46
Removing and installing components
After working inside your
computer.
Before working inside your
memory.
computer.