Table of Contents
Advertisement
If neither of these buttons is not pushed within 5 minutes, then the time adjustment mode resets. No adjustments
are saved.
Once all the parameters are set, push the
The vacuum cleaner carries out cleanup only on such week days for which the start time has been set.
To reset the cleanup mode on a particular day, push the
day on which you want the cleanup mode to reset. Several times push the
on the screen. Push the
Replacement of power supply elements causes resetting of parameters. Therefore, remember to re-adjust the time
after electric battery replacement.
ACCUMULATOR CHARGING
1.
CHARGING BASE USAGE
During use of the charging base, the necessity of charging the accumulator and the charging base location is
automatically determined by the device.
Place the charging base right against the wall beside a power outlet in a room to be cleaned, insert the adapter plug
into the outlet. This causes illumination of the signal indicator on the adapter.
There shall be no obstacles at a distance of 0.5 meter from two lateral sides, and at a distance of 1 meters from the
front side of the charging base. At the base location area, there shall also be no mirrors and intensively reflecting
surfaces within 15 cm heightwise from the floor. In case of presence of such surfaces, they shall be blanketed.
Do not place the base against a window if exposure to direct solar radiation is possible.
To avoid hampering signal reception and transmission, do not blanket the base in anything Otherwise, a error can
occur during charging. (Fig. 13)
To charge the vacuum cleaner, you should direct the device to the base while under the standby mode either by
pushing the
button on the control unit, or bring it to the base by hands. Make sure that contact leads on the base
align with contact leas on the device.
Do not leave the adapter unattended if energized after charging.
Do not leave the charging base on the floor for long when not in operation.
Attention! In is strictly prohibited to short-circuit the leads of the charging base!
Prior to a long-term storage, disconnect the accumulator. Do not keep the accumulator under subzero ambient
temperature.
2.
CHARGING THE ACCUMULATOR WITHOUT USING THE CHARGING BASE
Insert the adapter plug into the power socket on the vacuum cleaner body.
Connect the adapter to a power network. Do not turn off the charger until the accumulator is fully charged. Once the
charging is completed, the indication stars illuminating in green. Disconnect the adapter from the power network and
from the vacuum cleaner.
Make always sure to unplug the adapter after charging the accumulator.
Note:
If the device remains idle for a long time, it is recommended to carry out a drill in every 3 months having preliminarily
discharged the accumulator completely what requires continuous operation of the device for as long as possible.
Then, it shall be charged to the full followed by operating the device until having the accumulator approximately half
discharged.
You are advised to charge the accumulator only when the device signals about its upcoming discharge, or when having
it fully discharged. When fist-ever used, an accumulator can ensure autonomous operation of the device for up to
120 minutes. This value can decrease with time.
A depleted accumulator shall be disconnected and disposed as per local legislation and regulations.
button to save adjustments.
button to save adjustments and to exit.
button, then push the
65
button, and select a week
button until
icon illuminates
Advertisement
Table of Contents
