Upright SB60 Service & Parts Manual page 15

3.0 Introduction
Be sure to read, understand and follow all
information in the Operation Section of
this manual before attempting to operate
or perform service on any SB60 Work
Platform.
This section contains procedures for the operation
inspection, adjustment, scheduled maintenance, and
repair/removal of the SB60.
Section 2.0 will aid in understanding the operation and
function of the various components and systems of the
SB60 and help in diagnosing and repair of the machine.
Refer to Table 3-1, Preventative Maintenance Checklist,
for recommended maintenance intervals.
NOTE: Torque all hardware to torques listed on
page 3-29 unless otherwise specified.
SB60 Work Platform
Maintenance
T E R M I N O L O G Y
TERMINAL BLOCKS: Located in upper and lower
control boxes. Designated by TB##. (##) designates
the number of the block which is written on the termi-
nal block. "R" right or "L" may follow the number.
WIRE COLOR: Indicated by color/color. First color
refers to insulation color and second color indicates
stripe. If second color is not given there is no stripe.
FORWARD: Front of machine indicated by yellow
arrows on chassis.
AFT: Rear of machine indicated by orange arrows on
machine.
GENERAL PROCEDURES
CONTACT BLOCKS: Removed by inserting a flat
screwdriver into the slot at either end of block and
prying outward. Installed by pressing into an empty slot.
SWITCH MOUNT BASE: Assembled to back of switch
actuator. Removed by rotating the small black lever
counterclockwise and lifting off base.
TERMINAL BLOCKS: Remove wires by inserting a small
flat bladed screwdriver into square beside wire. Install
wires by stripping 1/2" of insulation, inserting screw-
driver in square and inserting wire. Be sure no strands
are bend backwards. Replace wires with same rating
and type.
Section
3.0
3-1