Upright SL-26N Operator's Manual

Specifications*

ITEM SL-26N
Platform Size (Inside Toeboards)
Standard 57.5 in. x 141.5 in. [1.46 m x 3.59 m]
w/ Extension 57.5 in. x 181.5 in. [1.46 m x 4.61 m]
Max. Platform Capacity
Standard 1250 lbs. [567 kg]
w/ Extension 1250 lbs. [567 kg]
on Extension 500 lbs. [110 kg]
Max. No. Of occupants
Standard 5 people
on Extension 2 people
Height
Working Height 32 ft. [9.75 m]
Max. Platform Height 26 ft. [7.93 m]
Min. Platform Height 59 in. [1.5 m]
Dimensions
Weight Electric 5,160 lbs. [2341 kg]
Kohler Gas 4,910 lbs. [2227 kg]
Kubota Gas 5,040 lbs. [2286 kg]
Kubota Diesel 5,100 lbs. [2313 kg]
Overall Width 66 in. [1.68 m], with standard tires
Overall Height 94.5 in. [2.40 m]
Overall Length 149 in. [3.79 m]
Drivable Height 26 ft. [9.75 m]
Surface Speed
Platform Lowered: Gas/Diesel 0 to 3.1 mph [0 to 5.0 km/h]
Electric 0 to 2.6 mph [0 to 4.2 km/h]
Platform Raised: Gas/Diesel 0 to .5 mph [0 to .8 km/h]
Electric 0 to .5 mph [0 to .8 km/h]
System Voltage Gas/Diesel: 12 Volt DC Electric: 24 Volt DC
Battery Charger (Electric only) 40 Amp 110 V 60 Hz (40 Amp 220 V 50 Hz, Optional)
Hydraulic Tank Capacity 12 Gallons [45.5 l]
Maximum Hydraulic System
Pressure 2500 psi [172 bar]
Hydraulic Fluid
Normal Use (>32 °F [0 °C]) ISO #46
Low Temp. Use
(-10 to 32 °F [-23 to 0 °C]) 5W-20 Motor Oil
Lift System One Single Stage Lift Cylinder
Lift Speed
Gas/Diesel Raise, 20 sec./Lower, 35 sec.
Electric Raise, 33 sec./Lower, 35 sec.
Power Source Two 4HP Electric Motors, Eight 6V 220 Amp/Hour
Batteries, 20 HP Kohler Magnum, 20 HP Kubota WG750,
20 HP Kubota D905 (Diesel)
Drive Control Proportional
Control System Proportional Joystick Controller with Interlock
Horizontal Drive Dual Rear Wheel, Hydraulic Motors
Tires B78-13ST Slab, 50 psi
Parking Brake Spring Applied, Hydraulic Release
Turning Radius (inside) 9 ft. 9 in. [2.97 m]
Maximum Gradeability Gas/Diesel: 30% [16°] Electric: 25% [14°]
Wheel Base 100 in. [2.54 m]
Guardrails 43.5 in. [1.11 m] high, Fold Down with Gate
Toeboard 6 in. [152 mm] High
* Specifications subject to change without
notice.
Hot weather or heavy use may reduce
performance.
FOR MORE INFORMATION
Local Distributor:
USA
TEL: (1) 800-926-5438 or (1) 559-662-3900
FAX: (1) 559-673-6184
Parts FAX: (1) 800-669-9884
801 South Pine Street
Madera, California 93637
http://www.upright.com
SL-30N
57.5 in. x 166.25 in. [1.46 m x 4.22 m]
N/A
1000 lbs. [363 kg]
N/A
N/A
4 people
N/A
36 ft. [10.97 m]
30 ft. [9.14 m]
59 in. [1.5 m]
Electric 5,470 lbs. [2481 kg]
Kohler Gas 5,220 lbs. [2368 kg]
Kubota Gas 5,350 lbs. [2427 kg]
Kubota Diesel 5,410 lbs. [2454 kg]
66 in. [1.68 m], with standard tires
94.5 in. [2.40 m]
173 in. [4.39 m]
30 ft. [10.97 m]
0 to 3.1 mph [0 to 5.0 km/h]
0 to 2.6 mph [0 to 4.2 km/h]
0 to .5 mph [0 to .8 km/h]
0 to .5 mph [0 to .8 km/h]
Gas/Diesel: 12 Volt DC Electric: 24 Volt DC
40 Amp 110 V 60 Hz (40 Amp 220 V 50 Hz, Optional)
12 Gallons [45.5 l]
2500 psi [172 bar]
ISO #46
5W-20 Motor Oil
One Single Stage Lift Cylinder
Raise, 23 sec./Lower, 35 sec.
Raise, 33 sec./Lower, 35 sec.
Two 4HP Electric Motors, Eight 6V 220 Amp/Hour
Batteries, 20 HP Kohler Magnum, 20 HP Kubota WG750,
20 HP Kubota D905 (Diesel)
Proportional
Proportional Joystick Controller with Interlock
Dual Rear Wheel, Hydraulic Motors
B78-13ST Slab, 50 psi
Spring Applied, Hydraulic Release
9 ft. 9 in. [2.97 m]
Gas/Diesel: 30% [16°] Electric: 25% [14°]
100 in. [2.54 m]
43.5 in. [1.11 m] high, Fold Down with Gate
6 in. [152 mm] High
Meets or exceeds all applicable requirements
of OSHA and ANSI A92.6-1999
Refer to Service Manual for complete parts
and service information.
12
060588-012
All personnel shall carefully read, understand and follow all safety rules,
operating instructions and the Scaffold Industry Association’s MANUAL OF
RESPONSIBILITIES (ANSI A92.6) before operating or performing maintenance on
NEVER operate the machine
within ten feet of power lines.
THIS MACHINE IS NOT IN-
SULATED.
NEVER operate the machine without first surveying the work area for surface hazards such as
holes, drop-offs, bumps and debris before operating machine.
NEVER operate the machine if all guardrails are not properly in place and secured with all
fasteners properly torqued.
SECURE gate across entrance after mounting platform.
NEVER use ladders or scaffolding on the platform.
NEVER attach overhanging loads or increase platform size.
LOOK up, down and around for overhead obstructions and electrical conductors.
CHECK all four tires for correct inflation. See Specifications.
DISTRIBUTE all loads evenly on the platform. See the back cover for maximum platform load.
NEVER use damaged equipment. (Contact UpRight for instructions, see toll free number on back cover.)
NEVER change operating or safety systems.
INSPECT the machine thoroughly for cracked welds, loose hardware, hydraulic leaks, damaged
control cable, loose wire connections and wheel bolts.
NEVER climb down elevating assembly with the platform elevated.
NEVER perform service on machine while platform is elevated without blocking elevating assembly.
NEVER recharge batteries near sparks or open flame; batteries that are being charged emit
highly explosive hydrogen gas.
AFTER USE secure the work platform against unauthorized use by turning key switch off and
removing key.
NEVER replace any component or part with anything other than original UpRight replacement
parts without the manufacturers consent.
Gasoline and diesel engine exhaust and some of their constituents are known to the
State of California to cause cancer, birth defects, and other reproductive harm.
07-02
Operator Manual
SL-26/30N SL-26/30N
SERIAL NO. 13300 to Current
WARNING
any UpRight aerial work platform.
SAFETY RULES
NEVER elevate the platform or NEVER sit, stand or climb on
drive the machine while el- guardrail or midrail.
evated unless the machine is
on a firm level surface.
California Proposition 65 Warning
1