Upright SL20 Operator's Manual

Operator Manual
All personnel shall carefully read, understand and follow all safety rules,
operating instructions, and the Scaffold Industry Association's MANUAL
OF RESPONSIBILITIES of ANSI A92.6-1999 before performing
maintenance on or operating any UpRight Aerial Work Platform.
NEVER operate the machine
within ten feet of power lines.
THIS MACHINE IS NOT
INSULATED.
NEVER operate the machine without first surveying the work area for surface hazards such as holes, drop-
offs, bumps and debris.
NEVER operate the machine if all guardrails are not properly in place and secured with all fasteners prop-
erly torqued.
SECURE chain across entrance after mounting platform.
NEVER use ladders or scaffolding on the platform.
NEVER attach overhanging loads or increase platform size.
LOOK up, down and around for overhead obstructions and electrical conductors.
DISTRIBUTE all loads evenly on the platform. See the back cover for maximum platform load.
NEVER use damaged equipment. (Contact UpRight for instructions. See toll-free phone number on back
cover.)
NEVER change operating or safety systems.
INSPECT the machine thoroughly for cracked welds, loose hardware, hydraulic leaks, damaged control
cable, loose wire connections and wheel bolts.
NEVER climb down elevating assembly with the platform elevated.
NEVER perform service on machine while platform is elevated without blocking elevating assembly.
NEVER recharge battery near sparks or open flame; batteries that are being charged emit highly explosive
hydrogen gas.
AFTER USE secure the work platform against unauthorized use by turning key switch off and removing
key.
NEVER replace any component or part with anything other than original UpRight replacement parts with-
out the manufacturer's consent.
SL20
Serial No. 9300 to Current
WARNING
Safety Rules
NEVER elevate the platform
or drive the machine while
elevated unless the machine is
on firm level surface.
NEVER sit, stand, or climb
on guardrail or midrail