Upright SB60 Service & Parts Manual page 10

Operation
Before operating work platform insure that:
Pre-operation and safety inspection has been
completed, and any discrepancies have been
corrected.
System function inspection has been per-
formed.
Operator has been thoroughly trained on the
operation of the machine.
Work area is clear of all obstructions, holes,
drop-offs, or persons in the route of travel.
Surface is capable of supporting wheel loads.
Refer to figures 2-2 through 2-5 for control locations.
Emergency Stop
At any time during operation, press the emergency
stop button to stop all functions in an emergency.
Service Horn
At any time during operation, press the service horn
button to sound an audible warning if necessary.
Always wear an approved fall restraint
properly attached to designated platform
anchorage point when driving or operating
the machine (see figure 2-6).
Attach only one fall restraint to each anchor-
age point.
Figure 2-6: Typical Fall Restraint Anchorage Point
2-4
Sarting the engine
From the lower controls
1. Turn the chassis key switch to chassis position.
2. Press the start button to crank the engine.
Release when the engine starts.
3. Diesel Engines: When the engine is cold, press
and hold the glow plug button for six seconds
prior to starting.
From the platform controls
1. Turn the chassis key switch to platform controls.
2. Turn the platform rotary switch fully clockwise to
crank the engine. Release when engine starts.
3. Diesel Engines: When the engine is cold, press
and hold the glow plug button for six seconds
prior to starting.
Driving
With Boom Lowered
1. Turn chassis key switch to platform, and pull out the
chassis emergency stop switch.
2. Mount the platform and close sliding rail.
3. Attach approved fall restraint to designated
platform anchorage point. Attach only one fall
restraint to each point.
4. Start engine.
5. Check that the area around and above the work
platform is clear of obstructions, holes, drop-offs,
persons in the route of travel, and the surface is
capable of supporting wheel loads.
6. Engage the interlock switch and move the drive
control handle forward to travel forward and
rearward to travel in the reverse direction.
Note: When the boom is rotated to the front of
the chassis (steering wheels aft) directions of
travel and steering will be reversed. Observe the
color coded arrows on the control panel near the
drive control handle, and on the chassis. They
will indicate the direction of travel when the drive
control handle is moved.
SB60 Work Platform