Upright SB60 Service & Parts Manual page 14

Maintenance
FUELING
Gasoline
1. Open left turret cover, open fill pipe cap.
(see figure 2-11)
2. Fill to capacity with unleaded motor fuel only.
3. Fuel tank full capacity is 42 US gallons.
Diesel
1. Open left turret cover, open fill pipe cap.
(see figure 2-11)
2. Fill to capacity with diesel motor fuel only, grade
#1-D, or #2-D. Use distillate fuel only, do not use
residual or blend.
3. Fuel tank full capacity is 42 US gallons.
HYDRAULIC OIL
1. Open left turret cover and check oil level at sight
gauge with the boom stowed and retracted.
Engine running or stopped. (see figure 2-12)
2. If necessary, fill to capacity with clean ISO
compatible hydraulic oil.
3. Clean area around cap before opening.
4. Open filler / breather cap to add hydraulic oil.
5. Replace cap.
LUBRICATION
Refer to service manual for lubrication chart and
guidelines.
Figure 2-11: Fuel tank
2-8
Fuel cap
BATTERY MAINTENANCE
Hazard of explosive gas mixture. Keep
sparks, flame and smoking materials away
from batteries.
Always wear safety glasses when working
with batteries.
Battery fluid is highly corrosive. Rinse away
any spilled fluid thoroughly with clean water.
Check battery fluid level daily, especially if work
platform is being used in a warm, dry climate.
If electrolyte level is lower than 3/8 in. (10 mm)
above plates add distilled water only. DO NOT use
tap water it will shorten battery life.
Keep terminals and top of battery clean.
TIRES
Tire selection can affect the stability of the machine.
Use only tires supplied by UpRight (15-19.5 NHS
Tubeless 14 Ply Rating ) unless approved by the
manufacturer in writing. Check tire air pressure
daily. (80 psi) (5.5 bar)
Hydraulic Oil Filler / Breather Cap
Figure 2-12: Hydraulic Oil Tank
Hydraulic Oil Level Gauge
SB60 Work Platform