Upright SB60 Service & Parts Manual page 7

Work platforms
Table of Contents

Advertisement

Section
2.0
All personnel shall carefully read, understand and follow all safety rules, operating instructions,
and the Scaffold Industry Association's MANUAL OF RESPONSIBILITIES (ANSI A92.5) before
operating or performing maintenance on any UpRight boom supported aerial work platform.
Electrocution Hazard
NEVER operate the
machine within ten (10)
feet of power lines. THIS
MACHINE IS NOT
INSULATED.
ALL occupants must wear an approved fall restraint properly attached to designated platform anchorage point.
Attach only one fall restraint to each anchorage point.
NEVER exceed maximum platform load of 500 lbs. (225 kg) and two (2) occupants.
NEVER exceed 45 lbs. (200 N) of side force per occupant.
DISTRIBUTE all platform loads evenly on the platform.
NEVER operate the machine without first surveying the work area for surface hazards such as holes, drop-offs,
bumps, curbs, or debris; and avoiding them.
OPERATE machine only on surfaces capable of supporting wheel loads.
NEVER elevate the machine when wind speeds exceed 28 mph (12.5 m/sec.).
IN CASE OF EMERGENCY push emergency stop button to deactivate all powered functions.
ALWAYS close and secure sliding rail after entering platform.
NEVER exit or enter platform while elevated.
NEVER use ladders, scaffolding, or other items to gain height; work only from the platform floor.
NEVER climb down elevating assembly while platform is elevated.
INSPECT the machine thoroughly for cracked welds, loose or missing hardware, hydraulic leaks, loose wire
connections, and damaged cables or hoses before using.
VERIFY that all labels are in place and legible before using.
NEVER use a machine that is damaged, not functioning properly, or has damaged or missing labels.
IF ALARM SOUNDS while boom is elevated, STOP, carefully retract boom and lower platform without rotating.
Move machine to a firm, level surface.
NEVER attach overhanging loads or use boom as a crane.
NEVER alter operating or safety systems without manufacturers written consent.
NEVER charge batteries near sparks or open flame. Charging batteries emit explosive hydrogen gas.
NEVER replace any component or part with anything other than original UpRight replacement parts without the
manufacturer's written consent.
NEVER tow the machine. Transport by truck or trailer only.
AFTER USE, secure the work platform from unauthorized use by turning both keyswitches off and removing key.
Gasoline and diesel engine exhaust and some of their constituents are known to the State of California to cause
SB60 Work Platform
O P E R A T I O N
WARNING
SAFETY RULES
Tip Over Hazard
NEVER operate the
boom or drive with
platform elevated
unless on firm level
surface.
California Proposition 65 Warning
cancer, birth defects, and other reproductive harm.
Collision Hazard
NEVER position the
platform without first
checking for overhead
obstructions or other
hazards.
Fall Hazard
NEVER climb, stand or
sit on platform guard-
rails or midrail.
2-1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents